Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
Fax +32 030 9904733
•
D
o not allow children, or irresponsible persons, to use the device without supervision.
•
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service
center or a professionally qualified, to avoid any risks.
INSTALLATION
•
After removing the packing materials, check the integrity of the heater; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger.
Attention
: any stickers or advertising material applied to the grid removed before using
the appliance. The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
•
Before connecting the appliance, check that the voltage values shown on the data plate
(220-
240V~ 50Hz) correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the appliance, have the outlet replaced
with another more suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the heater. In general,
the use of adapters or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must not be less that the
maximum of the heater.
•
The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
•
Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum distance
of 2 meters) to avoid the risk of it falling in.
•
Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
•
Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
•
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
•
Do not place the appliance near an open flame, cooking or other heating appliance.
•
Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
•
In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
Attention:
the fan can be used only when completely and correctly assembled, that is complete with its
base and protection grid.
Attention:
always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly,
refer to figure.
7
/
24
Assembly page 7/16
