Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
10
/
40
Assembly page 10/16
Fax +32 030 9904733
INSTALLATION
•
Installation must be performed by qualified personnel.
•
After removing the packing materials, check the integrity of the appliance; if you are unsure,
do not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger, but must be disposed of in accordance with regulations in the
appropriate containers for recycling.Attention: any stickers or advertising material applied to
the grid removed before using the appliance.
•
Before connecting the appliance, check:
a) that the voltage values shown on the data plate (220-240V~ 50Hz) correspond to those of
the electricity supply network
b) the electrical system to which the appliance will be connected must:
- Conform to current standards
- Have cables with an adequate diameter for the power consumption
- Have effective grounding and be in accordance with the applicable electrical safety
standards: in case of doubt, request an accurate check from professionally qualified
personnel.
•
For installation, it is necessary to provide an omnipolar switch with a
contact opening distance equal to or greater than 3mm.
•
Install the appliance at an appropriate distance from walls, objects, heat
sources, textiles (curtains, etc..) or volatile material, and at least 2.3 m
from the floor level.
•
Install the appliance to a masonry or metal ceiling / slab and / or material
that guarantees a support of a weight equal to at least 8 times the weight of
the appliance.
•
Before installation, check the following:
a)
that the appliance is in good condition
b)
that the elettric cables are not damaged
c)
that the omnipolar switch of the electrical network is in the off position (OFF). If the
appliance falls or receives a heavy blow, immediately check all components for
damage. If in doubt, have the appliance checked or assembled by a qualified
professional person.
•
Do not use the appliance with a timer or a programmer or with a system that can switch on
the appliance automatically, this avoiding the risk of damage to persons, animals or things.
•
In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help: repairs made by unqualified persons can be dangerous and
render void the warranty.
Make sure you have all the components before installation.
•
To prevent damage, assemble the appliance on a flat, smooth surface, without any
roughness, in order to avoid damage or scratches to the fan.
•
Attention: the fan can be used only when completely and correctly assembled. If in doubt,
have the appliance checked or assembled by a qualified professional person.
For the assembly , use the folowing figures as a reference (as a reference of the structural
parts), which is should be read before assembly.
For assembly, proceed as follows:
