20
Portable installation.
The appliance should be placed on a
horizontal, flat, smooth surface for this
procedure. The ends of the bottom of the
convection heater have holes for fixing the
feet; fit them and secure them with the screws
provided.
When done, check that the feet and
convection heater are securely fixed
together, that the feet are level and that the
heater is resting firmly on them.
Make sure that the power cable is correctly positioned and not in contact with hot
parts or sharp edges, or wound around the appliance or twisted.
In case of a fault or malfunction, switch the appliance off and have it checked by
qualified staff; repairs by unqualified staff may be dangerous and lead to the loss of
warranty cover.
USE
The appliance has the following control devices:
-
0/I Switch which turns the appliance on and off: on the side of the control panel
-
Electronic control panel with display and buttons for regulating the various
functions: on top, rear, side.
-
button activates the heating element (the SSS symbol appears on the
display) and all functions and also sets the appliance in standby mode.
-
˄
and
˅
buttons regulate both the temperature, between 5°C and 35°C (preset at
20°C) and the time (hours):
˄
increases,
˅
decreases.
-
PROG button activates daily and weekly programming of heating.
-
) button activates the default temperature (15°C) for the times when the
temperature is not set during the weekly programming.
-
Display shows the values of the temperature in °C, the time in hours, the days of
the week (1 stands for Monday, .... 7 for Sunday), and the use intervals.
-
“Window Open” warning: if the opening of a window causes a rapid drop in
temperature (5°C in 10 minutes, approx.), a beeper will sound 3 times in
succession, repeated.
-
“Power Blackout” warning: if the power fails temporarily, a beeper will sound 10
times in 30’. Press any button to stop it, press PROG to update the local time,
then press
to reactivate the previous programming.
-
Button lock: press the
˄
and
˅
buttons simultaneously for 3 seconds to
deactivate the keypad; repeat to reactivate.
-
Default reset. Press the
button for 5 seconds to return to the default
programming.
