Bimar 080306, Инструкция

Страница: 8 / 20

8
BIMAR LB 74 - 080306
Assembly page 8/28
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
USE
Your appliance is delivered with massaging rollers. In order to place them you only have to put
them in the therefore foreseen housings and to push them lightly. If you don’t want to use
them, please place the other accessories in the same housings.

Fill the tub of the unit with warm or lukewarm water (attention, your appliance is not
foreseen to heat water but rather to keep it warm enough during the treatment).

The mark ‘MAX’ shows the maximum fill level. If you want to fill the unit with less water,
please make sure that there is a sufficient amount of water over the foot rest surface.
 Place the unit on the floor in front of a chair. The rubber pads on the unit prevent it from
sliding.

Plug in the power cord and set the switch to the desired application.

Please sit down before putting your feet in the tub. Do not stand in the tub for a prolonged
period of time!

Relax and enjoy the gently stimulating foot massage and the refreshingly bubbling water.
You can enhance the effect with non-foaming bath oils.

To relax the sole of your foot, you can also lay your foot on the infrared insert situated on
the edge of the appliance. However, please note that the infrared heat will only be
produced if the programme selector is on a position including infrared heat. (see below)
 After 10-15 minutes you can end the foot massage bath and switch off the unit. Unplug
the power cord necessarily before emptying the tub.

We recommend resting afterward for an extended period of time (bed or couch) with
your legs covered.

To achieve long-term results, regular use (once or twice daily) is required.
Off
= Turns the unit off.
Massage Heat Infrared Heat = Foot massage with infrared heat
Massage Heat Bubble Infrared Heat = Foot massage, bubbles, warm water and infrared
Bubble Heat = Bubbles and warm water
PHYSIOLOGICAL EFFECTS
Proper use produces a measurable increase in blood circulation in the skin of the feet and then
in the legs, which manifests itself in a pleasant and lasting feeling of warmth (rise in skin
temperature) and in a relief in case of tiredness. Foot massage baths at regular intervals can
produce improved blood circulation in the feet and indirectly in the entire leg area as well.