E4-WM5-Y630A00
MOUNTING INSTRUCTION
created: 04.16.19 E4-WM5-Y630A00_2 Page 12 of 22 latest revision: 09.29.20
S.
Place the entire reservoir/bracket assembly under the rear quarter panel and mount to the two threaded holes in the
frame. Use an open ended 13mm wrench to thread in the Flange Head Cap Screw. Apply non-permanent thread
locker to the second Flange Head Cap Screw, then place it through the other hole in the Reservoir Mount Plate and
into the threaded hole in the frame. Now, slide the reservoir so that it’s almost touching the rear body mount bracket
as shown below. This should yield approximately ¼” clearance to the fender on the front side.
Torque both Flange Head Cap Screws to 18 ft-lb (25 Nm).
T.
Once the reservoir has been positioned as shown and confirmed to not be contacting anything on the vehicle, tighten
the Socket Head Cap Screw that was snugged down in step P.
Torque the Socket Head Cap Screw to 6 ft-lb (8 Nm).
