FORCE
TM
602V/X BLOWER Owner’s Manual
Part No 441502
441502_A_HI
8
TROUBLESHOOTING
*Using compressed air, or a backpack blower, you can
loosen or free debris easily from the impeller and housing,
which can cause wear and tear on the machine. You can
manually remove debris by taking off the front housing.
NOTE
: Always disconnect the spark plug when servicing.
(See
Fig
. 4 and 5)
Fig
. 6
Fig
. 7
Problem
Possible Cause
Solution
Abnormal vibration
Loose or out of balance impeller.
Check impeller and replace if required.
Debris in impeller.
Clear debris with compressed air or a
backpack blower (See
Fig
. 6 and 7 below).*
Loose engine.
Check engine.
Engine will not start
Engine not in full choke position.
Check choke position.
Out of gasoline or bad, old gasoline. Check gasoline.
Spark plug wire disconnected.
Connect spark plug wire.
Gas valve off.
Turn on gas valve.
Dirty air cleaner.
Clean or replace air cleaner. Contact a
qualified service person.
Engine is locked, will not pull
over
Engine problem.
Contact an engine servicing dealer for
engine problems.
Aim-N-Shoot
TM
lever sticking Debris stuck around cone.
Clean debis.
Cone adjustment knob too tight.
Apply silicone based lubricant to
Adaptor mount nut (item #43) too
pivot points.
tight.
Loosen manual adjustment knob.
Loosen nut.
NOT
FOR
REPRODUCTION
