FORCE PUSH BLOWER Owner’s Manual
Part No 440313
440313_E_HI
5
ASSEMBLY
1. The hardware for attaching the upper handle to the lower is in the parts bag.
Install upper handle (item 30), to preassembled lower handle (item 28) by
sliding the upper handle over and down the outside of the lower handle. Using
the bolts (items #36 and #71), washers (item #10) and lock nut (item #11) to
install upper handle to lower handle.
NOTE:
The Pigtail bolt should go on the
side that the pull start is on and the open end should be facing down. Finish
installing the other side of the upper handle assembly using screw and lock nut
provided. (See
Fig
. 1)
2. The throttle control will be attached to the throttle arm on the engine and
wrapped around the engine for shipping. Unwrap and secure
throttle control
(item #31) to upper handle with screws (item #17).
Screws will already be
mounted in handle. Simply remove and use to mount the throttle control
securing the cable with two Ty-wraps. The Aim-and-Shoot
TM
is not attached,
you will need to unroll the cable and attach the ball end to the lever and seat
the cable end into the hole on the saddle clamp, with the cable running through
the slot. To keep the cable from being damaged use three ty-wraps (item 74) to
secure it to the handle as shown making sure that the cable is not rubbing
against the tire. Note: the cable should be seated properly in the saddle and
should follow the contours of the handle. (See
Fig
. 2)
3.Connect spark plug wire.
Good routing
Bad routing
Fig. 1
Fig. 2
NOT
FOR
REPRODUCTION
