Billy Goat BC2601HHFCA, Руководство пользователя

Страница: 7 / 19

BC26 HYDRO-DRIVE Owner’s Manual
Part No 501551 7 501551_A_HI
MAINTENANCE
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation Every
Use
Daily or Every
5 Hours
Every 25
Hours
Every 50
Hours
Every 100-150
Hours
Inspect for worn or damaged parts

Check for excessive vibration

Inspect for loose parts

Sharpen blade. Note: nut will need to be
replaced when blade is removed

Inspect belts for wear

Lubricate throttle control cable and linkage

Check blade clutch cable tension

Apply anti-seize compound to rear axles

Replace blade drive and transaxle drive belts

*****TIPS*****
The best performance is achieved when cutting in dry conditions. The quality of the cut is directly related to ground speed during
cutting. Under most conditions cutting should be done at a slower ground speed. Fast speeds should be reserved for conditions
where weeds and brush are thinned out or not very tall. If the quality of the cut is not satisfactory, attempt at slower speeds.
NEUTRAL/FREEWHEEL
1. Identify the freewheel lever located in front of the right front
wheel when viewing from operator’s station.
2.
Pull lever to initiate freewheel motion.
3. Push lever in to initiate driver enabled motion.
Fig. 8 Freewheel Lever
NOT
FOR
REPRODUCTION