Part No. 360178 Form No. F012302A
Page 7 of 12
Never store engine indoors or in enclosed poorly ventilated areas
with fuel in tank, where fuel fumes may reach an open flame, spark or
pilot light, as on a furnace, water heater, clothes dryer or other gas
appliance.
If engine is to be unused for 30 days or more, prepare as follows:
Remove all gasoline from carburetor and fuel tank to prevent
gum deposits from forming on these parts and causing possible
malfunction of engine. Drain fuel outdoors, into an approved
container, away from open flame. Be sure engine is cool. Do not
smoke. Run engine until fuel tank is empty and engine runs out of
gasoline.
NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable alternative in minimizing
the formation of fuel gum deposits during storage. Add stabilizer to gasoline in
fuel tank or storage container. Always follow mix ratio found on stabilizer
container. Run engine at least 10 min. after adding stabilizer to allow it to reach
the carburetor.
This unit is equipped with a folding upper handle for easier storage.
TO FOLD THE HANDLE:
1. Remove the lock nuts that secure the handle, one on each side,
to the lower handle mounting studs. See Fig. 1
2. Remove the hair pins that secure the tine lift rods, one on each
side, to the tine lift links. See Fig. 2
3. Slide the rods out of the lift links and replace the pins in the holes
they were removed from for storage.
4. Rotate the lift rods down and back until they and hanging down
and to the rear of the unit.
5. Loosen the handle mounting knobs, one on each side, (Fig. 3)
and push the handle out and away from the lower handle mounting
studs.
6. The handle is now free to rotate. Rotate it up and toward the
front of the unit while holding the tine engagement control lever
against the rear of the upper handle. The handle will rotate into a
position with the top of the handle hooking over the front bumper of
the unit.
NOTE: Replace the lock nuts (item 50) on the lower handle
mounting studs for storage.
FOLDING HANDLE
OPERATION
continued
16
16
16
16
16
UNIT STORAGE
Fig. 1
Fig. 2
Fig. 3
NEVER PARK THIS UNIT ON A SLOPE OF ANY KIND.
Always keep tines in the up position when parking the unit.
PARKING
This unit is equipped with a height adjustable upper handle to allow
for multiple operator heights.
TO ADJUST THE HANDLE HEIGHT:
1. Remove the lock nuts (item 50) that secure the handle, one on
each side, to the lower handle mounting studs. See Fig. 1
2. Loosen the handle mounting knobs (item 51), one on each side,
(See Fig. 3) and push the handle out and away from the lower
handle mounting studs.
3. The handle is now free to rotate. Adjust the handle to the
desired height. The BOTTOM handle mounting stud coresponds
with the highest handle position. The TOP handle mounting stud
coresponds with the lowest handle mounting position.
4. Completely tighten the handle mounting knobs (item 51), and
replace the lock nuts (item 50) to secure the handle in place.
ADJUSTING HANDLE HEIGHT
