Billy Goat 100515001, Руководство пользователя

Страница: 11 / 23

SC180HEU Owner’s Manual
Part No 371515 Form No F102215B
11
TROUBLESHOOTING
When servicing engine refer to specific
manufacturer’s engine owner's manual. All engine warranty is covered by the specific
engine manufacturer. If your engine requires warranty or other repair work contact your local servicing engine dealer. When
contacting a dealer for service it is a good idea to have your engine model number available for reference (See table page 15). If
you cannot locate a servicing dealer in your area you can contact the
manufacturer’s national service organization.
To reach:
American Honda: 800-426-7701
WARRANTY CLAIM PROCEDURE
Should a BILLY GOAT
®
machine fail due to a defect in material and/or workmanship, the owner should make a warranty claim
as follows:

The machine must be taken to the dealer from whom it was purchased or to an authorized Servicing BILLY GOAT
Dealer.

The owner must present the remaining half of the Warranty Registration Card, or, if this is not available, the invoice or
receipt.

The Warranty Claim will be completed by the authorized BILLY GOAT Dealer and submitted to their respective BILLY
GOAT Distributor for their territory Attention: Service Manager. Any parts replaced under warranty must be tagged and
retained for 90 days. The model number and serial number of the unit must be stated in the Warranty Claim.

The distributor service manager will sign off on the claim and submit it to BILLY GOAT for consideration.

The Technical Service Department at BILLY GOAT will study the claim and may request parts to be returned for
examination. BILLY GOAT will notify their conclusions to the distributor service manager from whom the claim was
received.

The decision by the Technical Service Department at BILLY GOAT to approve or reject a Warranty Claim is final and
binding.
Make sure that the product is registered with Billy Goat. For online product registration go to
www.billygoat.com
Problem Possible Cause Solution
Engine will not start Choke not on. Out of gasoline, bad or old gas. Spark plug wire
disconnected. Dirty air cleaner. Blade clutch is engaged Check Gasoline. Check for spark with an approved tester.
Clean or replace air cleaner. Disengage the Blade clutch
lever.
Engine runs poorly Spark plug wire loose. Carburetor out of adjustment. Water or dirt in
fuel system. Spark plug fouled, faulty or wrong gap Sharpen or replace blade. Adjust carburetor (refer to engine
manual). Reset gap or replace spark plug (refer to engine
manual).
Belt slips Belt tension inadequate. Too deep of a working depth. Belt worn. Replace belt. Replace blade
Abnormal vibration · Loose or out of balance blade. Bent blade. Loose engine bolts Stop work immediately. Check blade mount and balance.
Replace damaged or bent blade if required. Check engine
mount.
Will not cut or has poor cutting performance Dull or bent Blade. Debris locked against blade. Engine running at
too low RPM. Sod is too dry. Sharpen or replace blade. Remove debris. Check engine
RPM (refer to engine manual). Apply more water to cutting
area to loosen sod
Drive will not engage Shifter in neutral. Out of adjustment drive cable. Broken drive cable.
Worn or broken belt. Shift lever to desired direction and speed. Adjust drive
cable. Replace with new cable. Replace belt.
Drive will not release Drive cable out of adjustment. Damaged drive lever. Adjust drive cable. Replace drive cable.
Engine is locked, will not pull over Debris locked against blade. Damaged engine. Remove debris. Refer to engine owner's manual. Replace
control cable.