Quick Start Guide
2
Hardware Overview
The Front LEDs
The Rear Ports
* Note: For WPS configuration, please refer to the WPS section of User Manual.
Connect the supplied
power adapter to this
jack.
Connect the supplied RJ-11
(“telephone”) cable on this
port when connecting to the
ADSL/ telephone network.
Connect your computer
to a LAN port, using a
UTP Ethernet cable.
Connect the
antenna.
Lit when connected to an
Ethernet device. Green for
100Mbps; Orange for 10Mbps.
Blinking when data is
Transmitted / Received.
Lit green when IP connected.
Flashes green when IP connected
and IP traffic is passing thru the
device. Lit red when device
attempted to become IP connected
and failed. Lit off in bridged mode or
when connection WAN is absent.
Lit orange red when
power is ON. Lit red
means system is fail.
Lit green when the
system is ready.
Lit green when the wireless
connection is established.
Flashes when the device
sending /receiving data. Flash
once per second while wi-fi
protected setup is in progress
Lit green when
successfully connected
to an ADSL DSLAM
(“Line sync”)
Lit green
when there
are emails in
the inbox.
Press it to reset the
device or restore to
factory default settings.
Push WPS button to
trigger Wi-Fi Protected
Setup function*.
BiPAC 7402X(L) does not support 802.11g and WPS functions.
Power ON/
OFF switch
Connect the USB
cable on this port.
Lit when the USB
device is ready.
Flashes when
sending /
receiving data.
