Quick Start Guide
Hardware Overview
The Front LEDs
The Rear Ports
Connect the
supplied power
adapter to this jack
Connect this port to the
ADSL/telephone network
with the RJ-11 cable
(telephone) provided.
Press it to reset
the device or
restore to factory
default settings
Connect a UTP Ethernet
cable (Cat-5 or Cat-5e) to
one ofthe LAN ports when
connecting to a PC or an
office/home network of
10Mbps or 100Mbps.
Connect the
detachable
antennato this port.
Lit orange red when
power is ON. Lit red
means system is fail.
Lit green when the
system is ready.
Connect this port to
the telephone jack on
the wall with RJ-11
cable.
Lit when connected to an
Ethernet device.
Green for 100Mbps;
Orange for 10Mbps.
Blink when data is
Transmitted / Received.
Lit green when the
phone is off hook.
Lit Green when the device is
successfully connected to an
ADSL DSLAM. (“line sync”)
Lit green when a
wireless connection is
established. Flash
when the device is
sending/receiving data.
Power
ON/OFF
switch
Lit when the inbound
and outbound calls
are transmitted
through PSTN.
Lit green when the
SIP Registration is
OK.
Push WPS button to
trigger Wi-Fi Protected
Setup function.
Lit red when WAN port fails
to get IP address. Lit green
when WAN port gets IP
address successfully. Lit off
when device in bridged
mode or WAN connection
not present.
Connect this port to
an analog phone set
with RJ-11 cable.
Lit green when the
USB device is ready.
Flashes when
sending/ receiving
data.
3G/ HSDPA USB
modem backup for
Internet access
-2-
