Bilanciai FLYNET 100, Инструкция по использованию, обслуживанию и монтажу

Страница: 59 / 125

57
FLYNET 100
5.2.2 Serial Ports
From this page it is possible to set the serial transmission parameters of the COM ports.
The COM ports that are always physically present are: COM4, COM6 and COM7.
If an optional serial expansion board is installed the COM ports are: COM8 and COM9.
Instead a possible USB/Serial port converter uses COM higher than 10.
Always save the configuration before exiting if some parameters have been changed.
The editable features for each COM are:
baud rate 4800
9600
19200
38400
115200
Bits 7
8
Stop bits 1
2
Parity No
Even
Odd
Handshake No
Hardware (COM4 and COM8)
Xon/Xoff (COM6, COM8 and COM9)
Protocol RS232 (on: COM4, COM6,COM8 and
COM9)
RS422 (on: COM7 and COM9)
5.2.3 Printers/Readers/IOs
Press the "Printers/Readers/IOs" key to access the settings area of the following components:
System Axis
managem
ent Strictly related to the activation of the service. It cannot be used if the
axis management service has not been activated from the relevant
menu. For configuration, follow the instructions in chapter
Errore.
L'origine riferimento non è stata trovata. Errore. L'origine
riferimento non è stata trovata. .
System
Memory Service that checks the internal memory use and signals when the set
limits are exceeded.
Memory almost full Set at what percentage the memory almost full