ENGLISH
9 |
P a g e
Copyright © 2012 Bike2Power. All rights reserved
b.
Use the provided bracket bolts and washers (C3). These bolts are
provided in two different lengths. Select the length that best
accommodated the diameter of the fork
c.
Tighten the bolts for the firm hold. Do not over-tighten.
Step 3. Adjust dynamo position
a.
Dynamo’s friction roller (B1) should be firmly touching the middle of
the tire at a right angle
b.
Adjust the friction head’s position to the correct position by slightly
loosening the bolts and adjusting the roller’s height, angle, and
distance until the correct position is reached.
Step 4. Tighten the bolts
a.
Once the correct position is reached, tighten all bolts to achieve the
firm grip.
b.
Avoid over-tightening.
To Remove the Dynamo
a.
Loosen the bolts and remove the brackets from the fork.
To Disengage the Dynamo
The dynamo may be disengaged without removing it while not in use
a.
Press the release lever down
b.
The dynamo will snap away from the rim
c.
Reengage by pressing the release lever and pushing the dynamo
toward the tire until it clicks in place
Mounting LightCharge® USB Charger
LightCharge® may be mounted on any of the bicycle tubes. When choosing a
location, ensure the length the cable (A2) is sufficient to for the LightCharge®
connectors to reach the bottom of the dynamo.
Step 1. Select the desired location
a.
Select the mounting location.
b.
Make sure the cable’s connectors can reach the bottom of the dynamo.
Step 2. Mount LightCharge®
a.
Optional – use the protective mounting pad provided between the
charger and the tube to prevent slippage.
b.
Position LightCharge® in top position A1. USB charger port (A5) may
be facing a direction that best suits your charging needs
c.
Use the zip ties provided to secure the LightCharge® by inserting
them through the mounting slots (A4).
d.
Cut off the excess zip ties.
