****THIS ASSEMBLY MIGHT REQUIRE TWO PERSONS. PLEASE ASSEMBLE WITH CARE. SAFETY FIRST!!
1. Determine location of the Bike Tree Ultra Max HD. Allow sufficient room to fit all items to be stored.
You will need approximately 5 feet of wall space. More space will be needed if bicycles or longer objects are stored.
2. Remove all packaging from all cartons.
3. Bike Tree Hub Aseembly (4 - if using):
a. Disassemble the plastic hub.
b. Insert the hanger rod (or utility hook) from the back of the hub front, making sure that the end hooks are correctly oriented. At this time, determine the angle of the hanger rod.
c. Close hub by sliding the hub rear into the hub front body.
d. Set aside.
8. Lower Main Assembly (2):
a. Insert leg tubes to the angled ends of the base.
b. Insert lower vertical tube to the stub end of the base.
c. Insert slider onto the vertical tube. Slide all the way to the bottom and secure using a short pin
d. Insert one Bike Tree Hub assembly into the main bottom tube. Temporarily secure with short pin at any position except the top 6 holes.
e. Insert another slider (make sure it faces the same direction as the first slider). Insert at the position just below the locking button of the vertical tube.
Secure with short pin.
f. Repeat steps a-e for the opposite side, making sure the sliders are rotated the opposite way.
g. Set aside..
6. Upper Main Assembly (2):
a. Insert one Bike Tree Hub assembly into the upper vertical tube. Slide all the way to the top. Secure with short pin to the highest tubing hole.
b. Insert slider into the upper vertidal tube. Slide as far as possible towards the top. Secure with short pin on the upper slider hole.
c. Repeat steps a-b for the opposite side, making sure the slider is rotated the opposite way.
9. Attach the Upper Main Assembly to a Lower Main Assembly. Make sure that the sliders face the same direction.
Repeat for the other side
10. Lean units up against a wall, making sure that the vertical tubes are vertical and leg tubes are evenly spaced from the wall. Space the units approximately 63" apart.
11. Attach the cross tube sets (6). To properly secure, insert the tube past the button hole, insert second tube and adjust accordingly.
12. Adjust lower hubs to your preferred location.
13. Hang wire grids and adjust accordingly.
Questions/Comments?
Contact us:
Sure Trak Corporation
1701 W. 10th Street, Suite 18
Tempe, AZ 85281 USA
480-968-2656
