www.bikefriday.com
800-777-058
•
+1-541-687-0487
Travel Trailer Assembly
Your Trailer Parts:
If you purchased a
TravelTrailer with your bike,
you should have two trailer
wheels and two yellow felt
bags with the tongue and axle.
The bottom of your TravelCase
should have three holes drilled
in it if you ordered the trailer
with your bike. If you ordered
the TravelTrailer system
separately, you will need to find the three dimple marks in the
bottom of your case and drill them through with a ¼” drill. Please
note the hole for the tongue (in contrast to the two holes for the
wheel axle) is offset slightly. The reason for this is for the telescop-
ing handle. There is a cable running down the center inside the
aluminum tunnel; offsetting the bolt allows the bolt for the trailer
to pass through the aluminum tunnel without striking the cable.
Remove Thumb Nuts
Remove the parts out of the felt
bags and remove the thumb nuts
and one of the washers from
each of the three threaded bolts
(leaving one washer over each
stud post).
Install the Trailer Tongue
Turn the TravelCase upside
down (while closed). Slip the
hollow end of the tongue over
the end of the T-piece. Take the
trailer tongue and insert its bolt
through the corresponding hole
on the travel case (through the
aluminum tunnel). Note: The
gentle curve in the tongue is
located on the same side as the
side latch.
Fig 3. Install trailer tongue.
Fig 2. Trailer thumb nuts.
Fig 1. Trailer parts.
