2
Typical Tools Needed for Installation
Tape Measure
½” Masonry Drill Bit Drill (Hammer drill recommended)
Hammer
Anchor Set Tool (included)
Triple Slot Nut Driver (included)
3/8” drive ratchet
Marker or Pencil
SAE hex key set
Level
Wall Mounting or Vending Machine Mounting
1.
Identify mounting location. Be sure to follow setbacks. The base of the electric pump should be
mounted greater than 37" from the ground. If installing on a vending machine, mount in a position
that does not inhibit the door opening (we usually mount on the left side of the machine).
2.
Choose your mounting surface and fasteners. If mounting to sheet metal, we recommend using #14
sheet metal screws no longer than 3/4". If mounting into concrete, we recommend using a ¼”
masonry screw. If mounting into wood framing, we recommend using #14 wood screws.
3.
Before installing the screws, install the rubber backed washers with the sheet metal screws to
prevent water intrusion. Be careful not to over tighten the screws during install.