The Bike Barn – Standard Size Instructions
Page 4 of 4
The Bike Barn
#11-211 Schoolhouse Street, Coquitlam, B.C. Canada, V3K4X9.
Tel: 604-521-6444 Fax 604-521-3143
4. Tent Installation
a)
Unfold the tent, locate the following and place tent at rear of frame.
b) 1 x Large Velcro flap at the rear of the tent. with 6 x pockets to accept the AP-tubes in ribs 2 – 7 per Detail 5..
c) Start by pulling the Large Velcro Flap under the base tube assembly and attaching together.
d)
Stand Inside the frame and pass an AP-tube through the pocket closest to the Velcro Flap. Connect each end to the first pair
of C Tubes. Continue this process for each of the C tubes and front B Tubes as shown in detail 5.
e)
Close the Bike Barn and locate the brass-grommet on each side of the tent. Remove the nut from the 8mm x 50mm bolt, in
third hole from the end, place grommet over it and secure with nut.
See detail 2.
f) Attach the six Velcro straps on the sides of the tent to the base frame, going underneath the frame from the outside. These are
used for adjusting the side tension of the tent.
g) Adjust the rear Velcro flap so that the tent fits correctly.
Security Features.
Your Bike Barn is now operational. The only thing left to do is to select the location for it.
Securing the Base Plate
You can secure the Base Plate to the ground using the two bolt holes. You can drill or into concrete or screw into wood to
permanently attached the base plate. For installations on ground you can drive spikes into the ground or use a realtors anchor that
screws into the ground like a corkscrew.
Securing the U brackets
Install the locking U-brackets, see detail-3
(fasteners not included) which secures the Bike Barn in the closed position, and the
optional lock bar assembly if required.
Lock Bar Assembly
:
(see Detail-4)
The lock assembly will install either on the left or right base tube. If you wish to install the lock assembly, remove the first 2 bolt
assemblies. (As indicated on detail-1) Place the LOCK TUBE over the B-tube and attach LOCK BAR to base tube-A. (2-places)
Close the tent and then slide the LOCK TUBE back over the LOCK BAR. By inserting a padlock (not supplied) through the hole
provided, the Bike barn can be securely locked in place.
Thank you for Choosing the Bike Barn. We believe you will have years of satisfaction with your purchase.
