Bihui MME1200, Инструкции по использованию

Страница: 7 / 8

Usage Instructions
English
7
4. Cleaning and Maintenance
Always be sure that the tool is switch off and unplugging before attempting to perform inspection and maintenance.
- The tool and its air vents have to be keep clean, regularly clean the tool's air vents or whenever the vents start to become obstructed.
- Check the all screws if be loosened or no periodically.
- Usually check the cord insulation if broken or not.
5. Accessories
- Do not dispose of electrical appliances in the household waste.
- Follow the local provisions for the disposal of electrical or battery products.
- Valuable materials can be recovered by recycling.
- The electrical or battery components used for construction are in accordance with the regulation European Directive 2012/19 / EU on
waste electrical and electronic equipment and transposition into national law., used electrical appliances must be collected separately
and recycled in an environmentally sound manner.
- Contact us for further information.
7. Warranty
- The guarantee covers all manufacturing or assembly defects in accordance with the legislation in force. The guarantee does not cover
malfunctions caused by improper use, overloads, failure to follow the operating instructions and normal wear and tear.
- For more detials and information, consult the general guarantee conditions at www.bihuitools.com
8. Attachments
CE Declaration of Conformity
- This accessory is recommended for use with your device specified in this manual.
- Using other accessories or attachments may result in personal injury. Only use accessories or accessories for the stated purpose.
6. Environmental Protection
Caution
!
No-load speed reduction
- The electronic control reduces the no-load speed of the machine which results in reduced noise and wear of motor and gear.
Speed pre-selection
- With the speed control, the speed can be continuously pre-selected.
- The necessary speed is dependent on the type of material to be mixed. it is recommended that it be confirmed, with a practical trial.
Speed selection
- Two rpm ranges can be pre-selected with the speed selector switch.
Speed 1: 150 - 300RPM
Speed 2: 300 - 650RPM
- The necessary speed depends on the type of the material mixed and it is recommended to verify it by a practical test.
Constant Electronics
- The constant electronics keeps the speed between no-load and load nearly constant and ensures uniform mixing of the materials.
Electronic overload protection
- In case that the machine is extremely overloaded, an electronic overload protection protects the motor from damage. In this case,
the motor stops and restarts only after the feeding pressure is reduced.
Temperature-dependent overload protection
- To protect the motor from overheating at extreme permanent load, it is switched off by the protective electronic system when a
critical temperature is reached.
- After a cooling-down period of approx. 3-5 min., the machine is again ready for use and can be fully loaded.
- When the machine is warmed by use, the temperature-dependent overload protection reacts earlier as a result.