10
11
Insert the chipboard decks
E
into each
level.
7
8
9
4
5
6
1
2
3
Insert a short side beam
B
into the
keyholes at the lowest shelf level
required.
Whilst pushing the beam
B
from the
rear, ensure the beam clips line up
with the keyholes. Tap the beam with a
rubber mallet and ensure that the beam
clips are fully located at the bottom of
each keyhole.
Repeat steps 1 and 2 until you have
created a “ladder style frame”.
Select two more posts
A
and repeat
steps 1 to 3 until you have a second
“ladder style frame”.
Bend centre support beam tabs at right
angles then slide the centre support
D
beams into the slots in the long beams
C
.
Now bend over tabs with a screw driver
to hold supports in place.
Tip: Now is a good
time to check the
space between the
beams suits the items
you want to store
on the shelves and
adjust as required.
If assembling as
part of a kit, please
see page 3 for shelf
spacings.
Take two long beams
C
and insert
them into keyholes on frame at the
same height as the short beams
B
.
Using the same technique push the rear
of the beam and tap into place with a
rubber mallet.
Insert the other ends of the beams
C
into the second frame as in step 5.
Tip: Ask another
person to hold the
frames in place while
you secure them.
Repeat steps 5 and 6 to add the
remaining long beams
C
.
Tip: use
the first
frame as a
template
to get the
correct
spacing.
Bend Fully Back
Diagrams for steps 8 and 9.
-
Please ensure
tab is folded flat
as shown
1
3
Slide in
180°
2
Bend to
P
A
B
A
B
C
C
D
E
B
2
Note: Illustrations not to scale
Assembly - RR1MGK Shelving Bay
