Setting Clock
After the unit is plugged into a mains supply or mains power failure, the display will
show the “0:00” on the LCD display. The unit should be in standby mode to set the
current clock.
1. Press MEM/TIME button, the digits for the display will blink.
2 .Press the PREVIOUS/NEXT button repeatedly until correct hour is set. Press the MEM/TIME to confirm.
The hour setting; the minute digits on the display will blink.
3. Press the PREVIOUS/NEXT button repeatedly until correct minute is set. Press the MEM/TIME to
confirm the minute setting.
Setting Alarm
Press and hold MEM/TIME button in shutdown state, the display will flash ON/OFF to select setting alarm or
canceling alarm.
Press PREVIOUS/NEXT to select ON, and the display will blink.
Press PREVIOUS/NEXT button repeatedly to set hour. Press MEM/TIME to confirm, then press
PREVIOUS/NEXT to set minute.
Press MEM/TIME to confirm.
The volume would turn up from 0 to 25 gradually.
Listening to the radio
1.
Press the button on the unit or the remote control to select RADIO mode. The unit will be in FM
radio mode.
2.
Select the desired radio station by pressing the PREVIOUS/NEXT
button.
3.
Press and hold PREVIOUS/NEXT button for 2 seconds, The unit
will automatically start and search the frequencies for the previous
or next strong station and stop on that station.
4.
Once you find a station you want to save, press the MEM button on the remote control, ”P01” will
be shown on the display, press M-up or M-dn until the desired memory position number appears
on the display. Press the MEM again to confirm and save the current station.
Using the Line in
Analogue sound signals from other sources can input to the speaker. To select the LINE function button on
the tower or repeatedly press the source button on the remote control until the displace shows LINE. If you
connect with the smartphone. Please put on the mobile stand on the tower top panel.
Line in Jack
Requires a 3.5mm cable .
1. Connect a 3.5mm cable to the
jack. Connect the other end of the 3.5mm cable to an Mp3
player or other audio source.
2. Press the power button to turn the unit on.
3. Press the function button or source button on the remote to switch to Line In
mode.
4. Use the controls on the connected device to begin playing audio routed through the unit.
