Big Sky International, Inc. 970 W Broadway, Ste E289 Jackson, WY 83001 USA
pg 1 of 3
Revised 2019-08-15
www.BigSkyInternational.com 888-535-7085
Big Sky International, Inc. - Wisp 1P “Moon View” (MV) tent revD
Setup instructions:
1)
Clear the ground of any sharp options that will damage the tent floor.
2)
Unfold and insert 38cm (15in) pole into foot end pole pocket, if not already inserted. Pole pocket
has flap next to ground that open/closes. (See drawing below)
3)
Lay out the tent. Select site were water drains away from tent. Suggest foot end into the wind.
4)
Stake/peg four (4) main 1cm (3/8in) webbing loops:
a.
(1) Stake/peg head end with 1cm (3/8in) webbing
b.
There should be a straight line between head and foot end stakes/pegs. (2) Stake/peg foot
end with 1cm (3/8in) webbing.
Note: if strong wind these steps may be reversed since foot end should be staked/pegged
into the wind, but if you do the foot end first you will not able to see if ridge line between
poles is in a straight so may need to adjust foot end peg after staking/pegging head end.
c.
(3) Stake/peg the non-door side of Wisp tent, it should 90 degrees from straight line
between head end and foot end.
See drawing below:
Note: do not tighten stake/peg webbing loops yet.
** Warning **
The both sides silicone coated SuprSil
TM
fabric we use has a very high strength to
weight ratio, but it will burn so keep it away from heat or open flame.
We have enclosed a fabric swatch for a test burn… after burning a fabric swatch
you need to decide to either to accept the risk of using the product with this fabric
or return the unused product for full refund
.
