Copyright 2017 Big John Grills & Rotisseries
4
ASSEMBLY INSTRUCTIONS
This unit ships 90% assembled and we make sure the instructions for the remaining assembly easy to
follow and perform. Please follow the instructions below to ensure your grill is properly assembled for
safe operation and remember this is a commercial piece of equipment and therefore the materials used
to build it are of the best quality.
1. Remove grill from carton & legs from their boxes. Be sure to remove all packaging materials, tape,
and plastic coverings. Leave grill top banded to the firebox
2. Flip firebox upside down so leg sockets are on top.
3. IF YOU PURCHASED WHEEL LOCKS, follow these directions for attaching them.
4. Screw legs firmly into the sockets on the bottom of the firebox.
5. Flip grill right-side up and cut banding
STEP 1:
Disassemble current casters by taking nut off bolt and
pulling old bolt out.
Discard old bolt.
STEP 2:
Put new caster brake on yoke by inserting tab on brake
into the slot on the side fork of the yoke while also lining
up the slotted hole with the bolt hole on yoke. The shoe
of the brake will be on the inside of the yoke, near the
top.
STEP 3:
Put wheel between forks of yoke and run new longer bolt
with tabs facing outward, away from wheel and the “on/
off” symbols facing upward
STEP 4:
Attach nylon lock nut to bolt and tighten.
Do not over
tighten or wheel will not spin.
