Big Joe PTE 30 Series, Эксплуатация, техническое обслуживание, список запасных частей

Страница: 35 / 96

901467 5-5
5-1.6. Control Head Installation.
1. Position control head (1, Figure 5-2 ) on arm (7)
and feed the electrical harness into the control
arm.
2. Working inside the control head, install two
screws (2) and two washers (3).
3. Connect the electrical harness located inside the
control arm.
4. Install cover (12, Figure 5-1 ) and secure with six
screws (11).
5. Reconnect the batteries and turn on the keyswitch
(4,
Figure 12-7 ) and pull out emergency switch
(6).
5-2. STEERING ARM
5-2.1. Pneumatic Spring Replacement.
The steering arm pneumatic spring (9, Figure 5-2 ) is
replaced while the steering arm (7) is in the upright
position.
1. Remove six screws (12) and cover (13) from the
steering arm (7).
2. Support steering arm (7) in the raised position.
3. Remove clip (10) and pull pneumatic spring (9)
from stud (11).
4. Remove four screws (8) to free pneumatic spring
(9) from handle (7).
5. Reassemble in reverse order.
5-2.2. Steering Arm Removal
1. Remove the control head as described in para-
graph
5-1.1.
2. Remove the pneumatic spring as described in
paragraph
5-2.1.
3. Remove the connector from the control cable
located in the steering arm (1,
Figure 5-4 ) and pull
the cable out the bottom of the steering arm.
4. Remove two screws (4, Figure 5-4 ) and cover (2).
5. Remove two screws (16) and cover (14).
6. Remove two screws (26) and lift the steering arm
off the truck.
5-2.3. Steering Arm Installation
1. Install the steering arm in the reverse order of
removal.