MELBOURNE 4 DRAWER CHEST ASSEMBLY INSTRUCTIONS
Page 2 of 20
IMPORTANT - READ CAREFULLY RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
INFORMATION
•
Due the size of this product we recommend that it is assembled in thee room intended for use.
•
When you are ready to start, make sure that u have the right tools, plenty of space and a clean,
dry area for assembly.
•
Unwrap all packaging materials and place the components on top of the carton box or on a clean
floor to prevent it from scratching.
•
Check the pack and make sure you have all the parts listed.
•
Ensure that this product is fully assembled as illustrated before use.
•
Check all screws or bolts are tightened and inspect regularly
•
This product should only be used on firm, level ground.
•
Keep small parts out of reach of children.
•
Make sure the legs remain in contact with the ground.
WARNINGS
•
DO NOT use power tools to construct this product.
•
DO NOT tighten screws until fully assembled.
•
DO NOT over tighten screws or bolts.
•
DO NOT use this product if parts are missing, damaged or worn.
•
DO NOT stand or jump on the product.
CARE INFORMATION
•
Never use scourers, abrasives or chemical cleaners
•
To clean wipe with a sponge and warm soapy water. Do not use solvent based cleaners or
detergents as they can bleach or damage the product
•
Never drag or pull this product across the floor as this could cause damage to the joints and could
result in failure to the product that will invalidate the warranty.
