BIFFI FCB Series, Руководство пользователя

Страница: 19 / 30

Service Instructions
VCIOM-15313-EN Rev. 1 March 2022
15
Section 3: Actuator Reassembly
Actuator Reassembly
3.3.8.2 For FCBB315-SR, FCBB420-SR and FCBB525-SR models install the
lubricated spring cylinder (4-10) over the piston and up against the
O-ring seal on the flange of housing (1-10).
3.3.9 For FCBBXXX-SR-M3/M3HW and FCBBXXX-SR models, do the the following:
3.3.9.1 Install spacer (4-25) onto center bar assembly (8-10).
3.3.10 Apply a coat of lubricant to the spring (4-70). Install the spring into the spring
cylinder by carefully sliding the spring into the open spring cylinder end until the
spring contacts the head of piston (4-50).
3.3.11 End cap seal installation.
3.3.11.1 For FCBB415-SR, FCBB520-SR and FCBB725-SR models install O-ring seal
(5-15) onto end cap (4-20).
3.3.11.2 For FCBB315-SR, FCBB420-SR and FCBB525-SR models install O-ring seal
(5-10) onto end cap (4-20).
3.3.12 If removed, install stop screw/ES (4-30) into end cap (4-20) and set stop screw to
the approximated setting recorded in Section 2, step 2.1.2.
NOTE:
Position spring cylinder (4-10) so that spring tag (4-60) will be adjacent to accessory
mounting pads located on the actuator housing.
3.3.13 Install end cap (4-20) onto center bar assembly (8-10) by rotating the end cap in a
clockwise direction.
3.3.14 Position the end cap (4-20) so that the breather port is at the bottom and the stop
screw/ES (4-30) is at the top.
! WARNING
Do not allow end cap (4-20) to rotate during center bar assembly tightening. The end cap
must maintain the position as described in step 3.3.14.
3.3.15 Keep end cap (4-20) from turning by holding end cap with an adjustable wrench.
3.3.16 Using a ratchet and socket on the center bar assembly nut, rotate center bar
assembly clockwise (CW). This will cause end cap (4-20) to gradually screw further
onto center bar assembly (8-10).
3.3.17 Continue to rotate center bar assembly (8-10) clockwise until spring (4-70) is
fully compressed, spring cylinder is seated against the flange of housing (1-10) or
adapter (4-15), and end cap (4-20) is properly seated in spring cylinder (4-10).
3.3.18 Tighten center bar assembly (8-10) to the proper torque as specified in Table 3.