Bien Air 1601098-001, Инструкция по эксплуатации

Страница: 10 / 21

5.2 Changing the cutting tool
1. Pull the clamping ring to the rear and
gently insert the cutting accessory in
the microsaw handpiece up to the
thrust stop. Then release the clamp-
ing ring, which should freely return
to its initial position (
FIG. 2 step 1).
2. Gently push and pull the cutting tool
to check it is correctly attached
(
FIG. 2 step 2).
3. If the cutting tool is not correctly in
place, pull the clamping ring to the
rear, remove it and start operation
again.
WARNING
Follow the guidelines for use, according
to the Bien- Air cutting tool’s in-
structions. Never use a non- original
Bien-Air cutting tool if the tip is not com-
pliant, as there is a risk it can become
detached during the procedure and in-
jure the practitioner, the patient or any
third parties.
WARNING
The use of a non-original Bien-Air cut-
ting tool will prevent proper irrigation
of the surgical site through the orifice
of the cutting tool.
11
FIG. 2
Description of pictograms used
WARNING
Make sure that the cutting tool is cor-
rectly inserted by moving and rotating
the latter back and forth. The cutting
tool must remain in place.
WARNING
Avoid applying too much force as the
temperature may significantly increase.
This entails a risk of thermal necrosis.
CAUTION
The microsaw must be activated before
it is put on the bone. Perform cutting op-
erations with a slight pressure exerted
in the direction of the bone or hard tis-
sues.
WARNING
Never touch a cutting tool on a mi-
crosaw in motion.
5.3 Changingtheirrigation line
WARNING
Irrigation lines are single use. The ir-
rigation ring is reusable.
CAUTION
Prior to changing the irrigation line and
ring, always remove the cutting tool, as
it may damage the irrigation ring O-
rings.