Evobi Automations Pvt Ltd
www.firepen3d.bibox.in
15
3. Tutorial of parameter setting
1.
The layer height of general settings for the 0.1,0.2,0.3mm.if 0.3 mm, the model has
obvious sense of hierarchy, but it can reduce the time of printing;0.2mm,it is usually
be used; the fine print is set to 0.1mm, the printing surface is smooth, the print time
will be longer
2.
The shell thickness is set to a multiple of 0.4mm, such as 0.8, 1.2, 1.6., and so on.
3.
Enable retraction, it can avoid printing residue silk filament, the detail is in advanced
settings.
4.
For the general model. The bottom / top thickness is set to 1mm. If you print a
thinner object, the upper surface has an unfilled surface. This value can be increased
appropriately.
5.
The fill density is generally set to 5%--20%, and smaller objects or single wall models
can be set to 100% fill, and larger seal models can also be set to 0 fill.
6.
Print speed is set to 30mm/s--80mm/s range
7.
The print temperature is only the nozzle temperature of the extruder, the PLA print is
set to 200-210 centigrade, and the ABS is set to 240 centigrade
.
8.
The heating bed temperature for PLA is usually set to 45-50 centigrade, and ABS need
more then 80
.
9.
Support is divided into: no support for the None, Touching buildplate, everywhere,
full support for Everywhere. Print model has vacated part or larger slope need to
open the support function, Touching buildplate refers to the generation of support
between the platform and the supporting model. everywhere refers to in addition to
support generation between the platform and the model can also generate support in
the inner of the hang model, the specific choice depends on the display of model.
10.
The platform adhesion type is generally selected as None, the contact surface
between print model and platform is smaller, and when the printing model height is
higher, the adhesion can be opened, and the attachment type is divided into two
kinds, brim and raft ,and the specific difference reference software is introduced
.
11.
filament diameter defaults to 1.75mm
12.
flow default 100%, if diameter less than 1.75mm and lead to print model surface
filling unevenly, can increase this value appropriately, but seldom happened
.
