BiancaMed SleepMinder, Инструкция по эксплуатации, Страница: 2 / 5

ABOUT THE SLEEPMINDER
TM
The SleepMinder
TM
uses a specially-designed motion sensor to detect body movement associated with sleeping. It can
be used in the home, hospital or clinical setting.
USING THE SLEEPMINDER TM
1
SleepMinder
TM
uses a removable standard Secure Digital (SD) memory card to store the data. Make sure the
memory card is inserted in the slot and that the 'LOCK' tab on the SD card is set at unlocked. Push the SD card into the
slot until you hear a click. If the card is flush with the casing, it is inserted correctly.
2
Insert the power connector from the 12V DC adaptor and turn it on at AC wall outlet. There is no power switch on
the unit.
3 The small light on the rear will show green. There should be a single beep. This indicates that the unit is powered.
4 Put the SleepMinder TM on your side of the bed, at about an arm's length – 3ft (90cm) – from your chest. It is
important that the front of the SleepMinder
TM
(indicated by the BiancaMed logo) is facing toward your chest as
shown in the figure below.
5 Do not switch off the SleepMinder TM until you have finished the study – even if the study runs over a number of
nights.
•
The base of the SleepMinder TM should be above
the mattress, and up to a max 8” (20cm) higher.
• The green light should face away from you.
• Place at approximately an arm's length from you
(or 3ft [90cm])
Warning
• If SleepMinder TM is setup contrary to the operating
conditions above it may produce misleading results.