Cables should not exceed a maximum of 15 meters (~49ft) between any two RJ-45 microphone ports (whether
plenum box to plenum box or plenum box to CR-1).
Note: It is not possible to connect both a DCM-1 ceiling mic and a DTM-1 table mic to the same Devio
system.
12. Squeeze the height adjustment assembly and push or pull the pendant mic's cable until the microphone is at the
desired height. For assistance with determining the best hanging height for this, please see the article on
Configuring the DCM-1
Once the DCM-1 has been installed and connected to the Devio CR-1, it is necessary to select the correct elevation
angle range for the microphone within the Devio System Administration Utility (SAU) software. This ensures optimal
performance of the DCM-1's beamforming technology. The below steps will demonstrate how to configure the elevation
angle in the Devio SAU.
1.
2. Double-click on the device in the device list to open its control options.
3. Click on the drop-down next to "Elevation Angle" to select the appropriate angle range. By default, this will be set
to "0 to 30 degrees," but there are four selections available:
◦ 0 to 30 degrees
◦ 15 to 45 degrees
◦ 30 to 60 degrees
◦ 45 to 75 degrees
https://support.biamp.com/Devio/Hardware-Software/Installing_the_Devio_Ceiling_Microphone_(DCM-1)
Updated: Sat, 09 May 2020 10:35:30 GMT
Powered by
10
