10
Holding down the function button down will continuously change the DSP level. When the
desired level has been reached, release the button. The module will retain this level until it is
changed again. A short press of the Mode button will switch between DSP filter
“
On
”
and DSP
“
Off
”
(Red LED).
4.1.4 To switch between 4 and 8 level mode follow this procedure:
Switch the module power on whilst pressing and holding the function button.
Two slower beeps will be heard indicating that the module is in the set-up mode, followed by
three sets of two beeps then followed by 4 beeps and then 8 beeps.
Keep your finger on the mode button until you want to select either 4 or 8 levels.
For 4 level mode release the button when you hear 4 beeps.
for 8 level mode release the button when you hear 8 beeps.
The LED will go green for 4 level mode and orange for 8 level mode. Subsequent presses short
presses will scroll between filter on and filter off (red LED for both modes).
When Switched
“
On
”
the module recalls the last DSP filter level that was used with noise
cancelling on.
Installation inside typical extension speaker:
