BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 3514
Air Caulking Gun
SAFETY PRECAUTIONS
IMPORTANT
Failure to follow these precautions could result in personal injury, and/or damage to property.
•
ALWAYS wear approved impact resistant safety goggles. (Eye glasses are NOT safety
glasses).
•
ALWAYS disconnect the tool when not in use, before changing accessories and before carrying
out any maintenance
•
ALWAYS have trigger in the OFF position when connecting to an air supply.
•
ALWAYS keep a safe distance between yourself and other people when using the tool.
•
Maintain the tool with care. Keep it clean for best and safest performance.
•
Quick change couplings should not be located at the tool. They add weight and could fail due to
vibration.
•
DO NOT over-reach. Keep your proper footing and balance at all times.
•
DO NOT force or misuse the tool. It will do a better and safer job at the rate for which it was
designed.
•
DO NOT abuse hoses or connectors. NEVER carry a tool by the hose, or yank it to disconnect
from the air supply. Keep hoses away from heat, oil and sharp edges. Check hoses for weak or
worn condition before use, and ensure that all connections are secure.
•
DO NOT exceed 90 PSI at the tool.
•
DO NOT modify the tool in any way.
AIR SUPPLY
Tools of this type, operate on a wide range of air pressures. It is recommended that air pressure to
this tool does not exceed 70 PSI, at the tool when running. Higher pressure and unclean air, will
shorten the tools’ life because of faster wear, and could be a safety hazard. Water in the air line will
cause damage to the tool, ensure it is properly maintained at all times. The recommended procedure
to connect this tool to an air supply, is shown at fig. 1. The air inlet used for connecting air supply, has
a standard 1/4" thread. Line pressure, or hose inside diameter, should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 5/16" (8mm) ID., and
fittings should have the same inside dimensions.
TECHNICAL DATA
Max. Air Pressure: 90 psi (6.3 bar)
Recommended Pressure: 70 psi (4.8 bar)
Air Inlet: 1/4"
Noise Level: LpA 91.9 dB(A)
LwA 101 dB(A)
