BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
3.
Select suitable bell according to wheel-bearing housing diameter, place on the corresponding step
plate and select the corresponding pressure plate according to bearing diameter. The pressure
plate is employed in the optimal case for improved guiding with the bearing collar. If the collar
does not fit into the inner diameter of the bearing with play, the disk can also be inserted with the
collar on the outside.
4.
The individual wheel-bearing tool components are now placed on the spindle in the following
sequence: Pressure bearing, pressure sleeve, step pulley and bell. Insert this unit with the spindle
first into the bearing. Now place the suitable pressure plate, thrust washer and forcing nut (with
the screw-in aid first) on the other side.
Caution:
Before tightening in, check for correct seating.
Always tighten the spindle on the pressure bearing side and hold back with a spanner on the other
side.
When the bearing has been pulled out, the complete unit to the pull-out bell side can be removed from
the wheel bearing housing.
Now dismantle the tool again.
MOUNTING
5.
Mount front retaining ring into the wheel bearing housing as a limit stop.
