BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
LUBRICATION & MAINTENACE
•
Give 4 to 5 drops of pneumatic device oil into the pneumatic device via the air connection.
•
Check the pneumatic device before each using. The product must not be used if it shows cracks,
leaks or other damage.
•
Only use the pneumatic device if it can be controlled by the trigger, a jammed trigger carries a
risk of property injury and damage.
•
Only clean the pneumatic device with a dry cloth, do not use solvents, acidic cleaners, etc.
•
Do not immerse the pneumatic device in any liquid.
TROUBLESHOOTING (
I
nsufficient power)
Probable Cause
Solution
Dirty or clogged air
passages
Flush and lubricate tool, drain air tank and supply line
Insufficient air supply
Increase line pressure, make sure compressor matches tool's air
pressure and consumption needs
Air leakage
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Worn/damaged wear & tear
parts
Replace as necessary
Tool matching
Be sure you are using a tool suited for the sanding requirements of
the job at hand.
DISPOSAL
Dispose of this product in an environmentally friendly manner at the end of its life.
Recycle unwanted materials, such as packaging, instead of disposing of them as waste.
Contact your local solid waste authority for recycling information.