BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
1. CAUTION FOR USE
No.
Description
No.
Description
1
Air Tool
6
Dewatering / Filter Unit
2
Air Hose
7
Dewatering Valve
3
Quick Coupler
8
Shut-Off Valve
4
Oiler
9
Dryer / Filter Unit
5
Pressure Regulator
10 Compressor
1.1 Air pressure
Please always keep the proper pressure of air inlet at 90psi (6.3kg/cm²) to maintain the longest tool
life.
1.2 Air line
Use a 3/8” air hose between the compressor and the tool. Compressed air is cooled and its water
content separated, as soon as the air leaves the compressor. A portion of the water content, however,
is condensed in the piping, and can enter the tool mechanism, and may cause trouble. So, install an
Air Filter, Regulator & Lubrication and on oilier between the compressor and the tool. Use a 3 HP or
larger compressor for enough power.
1.3 Air hose
Clean the hose with a blast of compressed air before connecting the hose to air tool. This will prevent
both moisture and dust within the hose from entering the tool and causing possible rust or
malfunction. To compensate for unusually long hose (over 25 ft), the line pressure should be
increased accordingly. If the length of air hose over 25ft, it has been suggested to add an Air tank
(Capacity 200L) to prevent tools from too low power to run due to air pressure is not enough.
1.4 Inserted tools
Make sure to use impact-quality socket only, don’t use hand-tool sockets. The crack of sockets will
reduce the torque of air tool and may cause serious injury.
1.5
The approved eye protector, ear-muff, mouth-muffle and gloves should be worn when operate this
tool.
1.6
The working place shall be ventilated.
1.7
Release the on-off device in the case of energy supply failure.