quick guide
ROLL
ROLL
d
812084 00503_02 14-05-14
Z-wave nOde fOR shutteRs
Technical specs
normal operating voltage
250v ~ a.c. 50hz
Maximum load
1.8 hP
frequency range
868.42Mhz
wireless Range
up to 30m line of sight
Basic Operations
- the Magistro ROLL can be remotely controlled.
- the Magistro ROLL can be add/remove from the network by pressing the push
button on the front of the device, or by external switch
- the Magistro ROLL’s indicator light will indicate the status of the
Magistro ROLL.
Mounting
1. turn Off power by switching off the circuit breaker or removing the fuse and
test that power is off before wiring!
connect with 2 gang Push Button switch
2. ensure Magistro ROLL capacity matches the load requirements.
3. wall installation: connect it with your existing external switch, default is
two buttons with neutral position switch. Please see below wiring diagrams
& configuration Parameters.
4. Reapply power to the circuit at fuse box or circuit breaker to test the system
carefully, if the indicator light on Magistro ROLL blinks 30 seconds and then keep
breathing, it means the installation is in good condition.
5. turn Off the power again.
6. for wall installation: insert your external switch together with Magistro ROLL into
switch box being careful not to pinch or crush wires, and secure it with screws.
Reapply power to the circuit at fuse box or circuit breaker.
Maximum load:
250v ~ a.c. 50hz , 1.8hP
wall installation wiring diagram, connect with external switch: (see figure B)
Please note:
a 6a external fuse before the red wire live of the Magistro ROll
switch must be installed
in the installation for protect the Magistro ROLL switch
terminal Block
Push Button
indicator Light
shutteR
twO tOggLe switch
uP
dOwn
Push
ButtOn
switch
(uP)
PaRaMteR: 1
siZe: 1
vaLues: 2
Push
ButtOn
switch
(dOwn)
L
n
Magistro ROLL
Magistro
Magistro
