BFT CELLPRIM4GE, Руководство дилера

Страница: 31 / 36

P a g e | 31
Alternate Number to Call During Do Not Disturb Times.
9999 #
21X ???? #
X = button number (1-9. Enter 1 for 1 button system. Enter 0
for button 10)
???? = Alternative phone number to call out of hours.
Restore Defaults
9999 # 999 # Send with passcode string to clear all programming. N/A
Control by SMS
This intercom allows the user to send SMS commands to control the relays and check status as
follows…
1234# 1 # - Relay 1 momentary trigger.
1234# 2 # - Relay 1 latch ON or hold ON.
1234# 3 # - Relay 1 unlatch or switch OFF.
1234# 4 # - Relay 2 momentary trigger.
1234# 5 # - Relay 2 latch ON or hold ON.
1234# 6 # - Relay 2 unlatch or switch OFF.
Troubleshooting guide
Q. The unit will not power up. No LEDs on.
A. Check power supply voltage at intercom is within 14.8V DC. Cable length from PSU to intercom
should be less than 25 feet and in 14 gauge. Check the fuse.
Q. The unit powers up but is not showing network reception or will not respond to SMS .
A. This means the unit is not able to detect the network for some reason.
-Power off the unit, remove the SIM and check it in a mobile phone to verify it can make a call and
has calling credit.
-Disable any PIN code request if active on the SIM card.
-Check the SIM is a standard voice capable SIM. If you are unsure, contact your SIM card
provider to verify. Compatible networks are At&T and T-Mobile.
-Check the reception is medium or good. Poor reception is not sufficient.
-Power off, remove the SIM, use fine sand paper to lightly sand the SIM pads and contacts on the
GSM unit, lightly bend the contacts upwards so that they make better contact with the SIM and try
again.
Q. The unit calls the first number, but there is not enough time to answer before it diverts
to the next number.
A. Increase the no answer time as per programming instructions.
Q. The unit calls the first number but voicemail comes on before it can ring the second
number.
A. Decrease the no answer time as per programming instructions.
Q. The caller ID part does not work.
A. Be sure to program the caller ID part under 72 feature. If your number is a private or number
withheld, then it will not work.
-Even if you have already programmed a number to receive a call from the intercom, if you also
want that number to have caller ID access, it must be programmed under the 72 feature also.