h)
If required, fit the glow fibre material over the flame ports. To do this,
seperate into short strands and place randomly over the flame porting
area as shown below in Fig. 31.
This material is only supplied to
improve flame aesthetics and is optional to install.
Fig. 31
g)
Refit the glass panel as described in section 2.7, then light the
appliance as described as in section 3.2
IMPORTANT NOTE : PLEASE ENSURE THAT WHEN COMMISIONING THE
FIRE THE FLAME PATTERN IS EVEN ACROSS THE WIDTH OF THE BURNER.
IF AN UNEVEN FLAME PATTERN IS FOUND THEN RELAY THE QUANTITY
VERMICULITE TO ACHEIVE AN EVEN FLAME PATTERN.
Warning : Use only the logs supplied with the fire. When replacing the
logs remove the old logs and discard them. Fit a complete set of logs of the
correct type. Do not fit additional logs or any logs other than a genuine
replacement set.
This appliance does not contain any component manufactured from
asbestos or asbestos related products.
23
Place all over porting area of burner
