SPILLAGE MONITORING SYSTEM
This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue.
If this system operates the fire will go out. If this occurs, leave the fire for at least
three minutes then follow the lighting procedure as described in the previous sec-
tion.
In the event of repeated operation a GAS SAFE registered gas installer
must be called to investigate and rectify the cause.
CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool.
CLEANING THE TRIMS AND PAINTED METAL PARTS
Dependent upon the trim option chosen for use with this fire, there is a variety of
methods that can be chosen to clean the trim. All trims must only be cleaned with
a clean, damp cloth. Metal polishes must not be used on these trims. The trim is
best cleaned by removing it from the fire and placing it face up on a flat surface.
The trim is easily replaced by repositioning it on the fire and pushing it back onto
the magnets.
CLEANING THE FUEL BED
We do not recommend cleaning of coals or fuelbed components as these are
fragile and damage may result.
None of these parts must be washed or
exposed to any cleaning agents or water
.
Any damaged parts must be replaced by contacting your dealer or telephoning
D.F.A. Ltd. on the number stated on the rear cover of this book. Coals must only
be replaced with a complete and genuine replacement set and the fire must never
be run with the wrong number or damaged coals. The fuelbed must be
carefully re-assembled as stated in the following section.
6
Note : Prior to replacing the oxypilot on this product due to suspected
failure of the component, please remove all debris that has collected on
the lint guard of the oxypilot itself.
