Bfb RapMan 3.2, Руководство по эксплуатации, Страница: 5 / 47

Rapman 3.2 Operations Manual
Page 5
1. Introduction
Before first use, the RapMan needs careful setting up. The list below illustrates some of the essential operations which must be carried out before
operation:
It's very important to , especially if you have a multi-head unit. [check your firmware version]
Make sure the bed is clear of any build material
Check the bed is fitted correctly
Check the hot-end nozzles are clean from plastic debris
Check the bed is level
Check the bed is referenced to the extruder nozzles
Load the extruders correctly
Print a successful raft
Failure to carry out of the set-up procedures contained in this document will damage the machine. all
This document has been designed to illustrate the procedures and get you up and running as quickly as possible. Please take time to essential
understand how the process works and complete each procedure in the order set out in this manual.
Have a look through the
and sections. Pre-print checks Further operations
First setup can take 60 minutes depending on the skill level of the operator. After that, typical set up time before a print can range from 0-5 minutes.
Support is available by raising a ticket at www.bitsfrombytes.com
We welcome any feedback you may have, and wish you well in your 3D printing!