6
4. Handling the Motor
4-1 Connecting/Disconnecting the motor and motor cord.
Align and insert the motor pin firmly into the pin holes of the
motor cord connector and fasten the motor cord nut securely.
To remove the motor cord from the motor, unscrew and
detach the motor cord nut, and gently pull out the motor cord
connector.
4-2 Connecting/ Disconnecting the motor and hand piece
To insert the E-Type hand piece into the motor, align the hand
piece and motor, then turn until you hear a click (positioning
pins are aligned)
To remove the hand piece, simply pull the hand piece from the
motor.
Caution
- Care should be taken when using any hand piece attachment which requires lubrication (E-Type
micro motor).
- Following lubrication, stand the hand piece attachment vertically until the excess solution drains.
Wipe the hand piece then attach it to the motor.
- Do not connect or disconnect the handpiece until the motor has completely stopped.
5. Operation
5-1 Insert the power cord plug into the AC outlet and turn the
power switch on. When the power switch is on, the lamps and
indicator will come on.
5-2 Before using this system, make sure to operate the Foot Air
Calibration function.
5-3 Push the Gear Ratio Select Key to indicate the speed of the
attachment you will use.
*Check Table Below for Speeds
Hand Piece Gear Ratio
Indicator
Speed (min
-1
(rpm))
16:1
1 - 25
100 – 2,500
1:1
2 – 40
2,000 – 40,000
1:5
1 – 20
10,000 – 200,000
Motor
Motor Cord
Connector
Motor Cord
Nut
Motor Cord
Handpiece (Option)
Positioning
Gear Ratio Lamp
Motor Insert
Push