Beyerdynamic Unite TH, Быстрый старт

Страница: 19 / 46

e
n
g
li
s
h
Unite TH – Handheld Transmitter
19
The status indicator on the charger shows the
following information:
Indicator light Operating status
Off Device is switched off
Green • Device is ready to use
• No pairing information saved
Flashing yellow Pairing information is being
copied to the charger or receiver
Yellow Pairing information has been
stored in the charger
Flashing green/
yellow Device is being localised
Flashes red 5 times • No transmitter
• Too many transmitters
Flashing red rapidly • Operating error
• Charging error
In order to perform a simple pairing, proceed as
described in the following:
1. Set the desired group ID on the transmitter you want
to use for pairing. See chapter 5.2 for reference.
2. Insert only one transmitter into the charging slot of
the charger. If multiple transmitters are inserted into
the charging slots of the charger, the pairing will not
start and the status indicator
on the charger will
display an error (see table). Alternatively, you can
connect the transmitter to the USB port on the
charger via a USB cable.
3. Insert one or more receivers into the charging slots of
the charger to be paired with the transmitter. You
can also connect another receiver to the charger
using the USB port. Remove all receivers that should
not be paired. If there is no receiver in the charging
slots, the pairing information is stored in the charger.
This is used for later pairing without connecting the
transmitter to the charger.
4. In order to transfer the pairing information from the
transmitter to the receivers in the slots and to the
charger itself for future pairing, press and hold the
“Pair/Reset” button
on the charger for more than
2 seconds. The status indicator will flash yellow for
several seconds if the pairing is successful. The
status indicator will then remain yellow because the
pairing information is now also stored in the charger.
5. If you want to pair other receivers, remove the trans-
mitter and all receivers from the charger, set the
switch
to “Pair & Charge” and insert the unpaired
receivers into the charger. The pairing information will