Beyerdynamic TS 910, Руководство по эксплуатации

Страница: 17 / 28

17
2.3 Setting up
1. Push down the two snap locks on the right and left of the battery
compartment and open it. Now you can adjust the GT/MT switch and
the gain control .
2. Make sure that the transmitter and receiver are on the same frequency.
3. The LED of the
TS 910 C will flash for a moment when the transmitter is
switched on and indicates the normal battery status. When the LED fails
to flash, there is no battery inserted, the battery is leaking or inserted
incorrectly.
The battery status of the
TS 910 M can be seen in the LC-Display.
4. Connect the microphone or instrument to the input socket . Refer to
illustration below.
2.4 Adjusting the input gain
1. Switch on the TS 910 beltpack transmitter with the ON/OFF switch. Turn
the gain control fully anti-clockwise to minimum gain.
2. Speak into the microphone at the maximum level you expect to use. We
recommend you use the letter “U” as a spoken “U” has a relatively good
sine wave shape. Adjust the gain control to the desired gain. On the
NE 911/912/914 receiver the AF level must not show any clipping. When
miking instruments, play at the maximum level you expect to use.
8
7
1
7
7