32
1.2
How to connect the Antennae
Connect the antennae
to the TNC sockets and and set them at an angle (60°).
Please note that for diversity operation both antennae have to be connected. A weighting
circuit silently switches the signal with the better S/N ratio to the output.
Important:
Avoid obstacles between antennae and transmitter; otherwise the reception could be
disturbed.
1.3
Where to place the Receiver
•
Place the NE 300 diversity receiver in the same room or area as the transmitters. Ensure
that the NE 300 is installed as close as possible to the mixing console or amplifier so that
the display can be seen at all times.
•
Do not place the NE 300 receiver near digitally controlled equipment or other sources of
RF interference.
9
15
1.4
Connections
•
Connect the Audio output to the corresponding input of the mixing console or amplifier.
Use the
balanced Audio output
, when you connect the receiver to a mixer/amplifier
with a balanced input.
•
Use the
unbalanced Audio output
, when you connect the receiver to the “LINE”
input of an amplifier.
•
Make sure the Mic/Line level switch is switched to the correct position.
Switch to
“LINE”
, when you connect the receiver to a mixer/amplifier. When connecting
to a guitar amplifier you should choose “LINE”, or the volume may be too low.
Switch to
“MIC-IN”
, when you connect the receiver to a microphone input.
Incorrect positioning of the Mic/Line level switch can cause distortion.
•
Make sure the mains voltage shown on the power supply unit corresponds to the local
mains voltage.
•
Connect the power supply unit to the receiver or the power cable to the power
connection and to AC mains power.
•
Thread the power cable through the cable grip as shown on the illustration below. The
cable grip prevents the connector from being pulled off by accident.
10
12
11
11
14
16
