Beurer JBY 90, Инструкция по эксплуатации

Страница: 25 / 124

25
1. Position the baby unit so that it is in an elevated position and is not in
proximity to any other devices that may cause interference. Switch on
the baby unit with the button. The device will beep three times with
increasing volume and the baby unit power LED will light up red.
2. Set up the parent unit in the room where you are going to be, or clip it to
your belt using the belt clip.
3. Switch on the parent unit with the button. The device will beep three
times with increasing volume, and the parent unit power LED will light up
green when the baby and parent unit are ready to receive.
If there is no connection between the devices (baby unit not
switched on or out of range), an acoustic warning will sound on the
parent unit and the power LED will light up red.
transmission mode
Both power LEDs permanently light up green.
eco
+
mode
The power LEDs flash green every 6 seconds (see 4. Notes).
7 settings
adjusting the volume
You can adjust the volume in 8 levels on the parent or baby unit by press-
ing the or button. A high-pitched beep sounds when the maximum
volume is reached; a low-pitched beep sounds when the minimum volume
is reached.
sensitivity on the baby unit
Turn the volume control up or down to adjust the sensitivity on the parent
unit.