When setting the handbrake lock, you may need to squeeze the brake lever tighter
to apply to the lock.
Handbrake Lock
Handbrake Lever
TIP: You may find it easier to squeeze with one hand and use the other hand to set
the lock
Do not turn the power off while driving.
When driving indoors, drive at a low speed.
Be careful when driving in places with crowds of people and
heavy traffic.
Please pay attention to pedestrians and other obstacles
when reversing.
CAUTION
Make sure the power is OFF when you get on or off of the
scooter.
9. SETTING THE BRAKE
10. OPERATING INSTRUCTIONS – DRIVING
Ensure the seat has been lifted and locked into position, the steering column is unfolded and secured, and that
the battery is locked in place. Press the power button. The power indicator light will be on.
Check the remaining battery power before operating and charge if needed.
Ensure that the rear safety bar is extended and the locator pin correctly positioned as this provides anti-tip safety
(see ‘IMORTANT SAFETY MEASURES’ section).
Adjust the speed setting to the ‘Slow’ setting. (The speed settings sets the maximum speed the scooter will move
at. The speed from standing still up to that maximum speed is controlled by increasing the pressure on the right-
hand crank.
Ensure you are comfortable with the speed controls and how to move backwards and forwards.
Check the surrounding environment and road conditions are safe before driving.
Twist the right-hand crank to move and adjust the speed as necessary.
To stop simply release the right-hand crank, allowing it to return to its neutral position and squeeze the left-hand
brake lever. If you wish to apply the handbrake, squeeze the brake lever, then pull the handbrake switch towards
you.
To turn off, press and hold the On/Off button, and the power indicator light will turn off. Leave your scooter in a
secure place and keep the key with you in a safe place.
1.
2.
3.
4.
5.
6.
7.
8.
9.
The scooter will not move until you press the MODE button to put the scooter into 1st gear after turning it on.
11. BATTERY AND CHARGING INFORMATION
This product uses a 36V 8AH high-performance lithium-ion battery. Fully charge the battery
before first time use.
Turn the scooter power off.
Use the keys provided to unlock the battery tray at the back of the scooter, under the seat.
Remove the battery by sliding towards you
Plug the charging cable into the power adapter and plug in to the mains supply.
Insert the charger’s power plug into a mains power supply.
When charging, the red charging light goes on. The charging time will vary depending on the battery age and
temperature but in general it will take 3-6 hours to be fully charged. The indicator light will turn green when fully
charged.
1.
2.
3.
4.
5.
6.
LITHIUM-ION BATTERY
CHARGER
This product uses a AC100-240V/2A charger.
REMOVE AND CHARGE THE BATTERY DIRECTLY
Note: The braking distance will vary depending on the driving conditions.
Содержание LUPIN
Страница 1: ...LUPIN LUPIN PRODUCT MANUAL PRODUCT MANUAL ...