4
Assembly Instructions
1.
Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2.
Attach the Stretcher (C) between two Legs (B) by threading the M6 x 50 mm Bolts (1) with the Lock
Washers (2) and the Small Flat Washers (5) through the countersunk holes on the Legs and then screw
into the threaded inserts in the Stretcher. Tighten the bolts with the enclosed hex wrench.
C
B
B
1
2 5
1
2
5
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
Small Flat Washer
(4 used in this step)
⑤
Lock Washer
(4 used in this step)
②
M6 x 50 mm
Bolt
(4 used in this step)
①
