Installation
.((
(If the basin is being installed onto an uncut top)
•
Select the location of the basin on the top
•
Allow enough space between the basin and mixer to the wall.
•
Measure the diameter of the basin waste back nut and waste trap
nut being used to determine the hole size required, then draw this
onto the top for the hole to be drilled, if not pre-drilled.
•
Drill a hole on the inside of the cutout mark to allow insertion of
Jigsaw blade to cut the hole.
•
Cut the opening in the countertop along the inside edge of
the marked line.
•
Drill the mixer installation hole accordingly to the
mixer dimension if required.
•
Apply silicone to any cut face and allow to dry to prevent
moisture penetration
•
Install the mixer to the top and the waste to the basin according to
the manufacturers instructions.
•
Apply sealant to the bottom edge of the basin.
•
Carefully position the basin over the cutout, so the waste tail goes
through the hole and press down firmly.
•
Immediately wipe away any excess sealant, and fill any voids
as needed.
•
Verify that the basin has not moved out of position.
•
Allow the sealant to dry before use.
•
The connect the waste trap to the waste and water supply
pipes to the mixer
