6
HANGING THE MIRROR
The mirror comes with the option of hanging both in landscape or portrait
orientation. At the back of the mirror, there are 4 key holes 2 on the vertical side
and 2 the horizontal side.
To hang the mirror, you will need to drill two holes into the wall, ensuring that
there are no wires or pipes behind the wall before commencing.
1.
Ensure that the power is disconnected at the circuit
breaker, and that there is no risk of reconnection during
installation.
2.
Measure the distance between the two key holes.
3.
Make a note of the distance and mark their position on the
wall. Use a spirit level to ensure that the holes are level.
4.
Drill the 2 holes into the wall at the position marked using
a suitable drill bit.
5.
Insert the wall plugs into the holes.
6.
Insert the screws into the wall plugs, ensuring their heads
are protruding by approximately 3mm.
7.
Check to ensure the screws line up correctly and the mirror
can be safely hung from them.
8.
The mirror should now be connected to a suitable fuse
spur following current regulations and guidance. When
connecting ensure that enough cable is left to allow the
mirror to be safely removed.
9.
You will now be able to hang the mirror. Carefully lower
the mirror onto the screws, ensuring that is secure and will
not slide.
10.
Reconnect the power supply.
