3
SAFETY
•
This mirror should be installed by a qualified electrician.
•
This fitting is only suitable for connection to a 220-240V earthed supply
in accordance with current IEE wiring regulations, and should be installed
in accordance with local Building Regulations.
•
This is for domestic, indoor use only.
•
The fitting should be connected to a dedicated lighting circuit which
must be protected by a 5-amp fuse (or a 6 amp miniature circuit
breaker).
•
The electrical connection must be an adequate distance from the rear of
the mirror to prevent the risk of shorting with the mirror’
s casing.
•
Before installing the fitting ensure that the mains supply is switched off,
and that the appropriate fuse is removed (or appropriate circuit breaker
is switched off) before commencing installation. Ensure that measures
are taken to prevent the supply from being inadvertently reconnected.
•
If there is a “Minimum Distance” label, please do not allow flammable
materials to rest within that distance from the unit.
•
This product may contain delicate parts
–
be careful during handling and
maintenance to avoid breakage.
•
If any modification is made to the fitting it will invalidate the warranty
and may render the product unsafe.
•
A defective appliance may cause electric shock. Never switch on a
defective or damaged appliance. Disconnect the appliance from the
mains before seeking assistance.
•
This product is IP44 rated, and no part of the installation is allowed to be
within bathroom Zones 0 or 1. Installation is permitted within Zone 2.
•
This product must be earthed. Before commencing installation, ensure
that there are no pipes or wires located behind the wall that may be
damaged during drilling.
•
Ensure that the hanging location has been decided upon and marked
clearly to avoid unwanted damage to the wall due to incorrect
positioning.
•
Inspect the mirror to ensure there are no signs of damage prior to
installation.
•
Take care unpacking, do not use a sharp blade to open as this may
damage the mirror and void your warranty.
•
Once installed a bead of silicon can be applied between the mirror and
the wall around the unit. Never seal the bottom of the mirror to the wall,
as this may allow water to accumulate behind the mirror.
